Micro MIM Japan

Application

Titanium Hinge part

  • Titanium Hinge part
  • Titanium Hinge part
  • Titanium Hinge part
  • Titanium Hinge part

Material : Ti alloy, Ti-6Al-4V        Size : 4.7 mm x 1.2mm x 0.55mm.

 

Our micro metal injection moulding technology uses the world-leading fine titanium or titanium alloy powder, thus the tightest tolerance requirement among PM components will be achieved. Additionally, a high vacuum debinding-sintering furnace is deployed in our mass production, therefore high productivity of small complicated designed parts with good mechanical properties is also realised. In small, complicated parts production, the secondary process is not applicable especially in titanium or titanium alloy components. Since the fine powder is applied in micro metal injection moulding production, the surface roughness is low in as-sintered components. Moreover, same as other material micro metal injection moulding production, the side hole or any other additional hole design will be composed without any post-machining process. Therefore it is not only possible to realise the stable high-quality serial production of titanium or titanium alloy components but also possible to eliminate the machining oil or metal chip contamination without any post-cleaning process.